|Article number:||Closed Pressure Transfer Kit- ECONOMY|
|Availability:||In stock (1)|
This closed pressure transfer kit is completely built out and ready to rock. Designed to get your beer from a glass or plastic carboy into a clean, sanitized, and purged corny keg. The 'gas in' clamped to the carboy cap allows for a swivel nut attached to your gas line to be screwed on. Included in the kit:
HOW TO USE:
Fill your clean corny keg with starsan solution. Pressurize with CO2 and purge the headspace 3 times in short bursts. Hang the racking cane into a bucket to catch the starsan. Clip the black QD onto your keg's liquid out post. Push all of the starsan out of the keg into the bucket. Disconnect the gas from the keg and pull the vent to remove most of the pressure.
Be sure the entire racking cane and underside of the carboy cap has recently been in the starsan bucket before inserting on top of your carboy.
Secure the carboy cap on top of your fermenter. Lower your CO2 regulator until the gauge reads zero. Hook up the gas line to the MFL fitting on the carboy cap.
Pull up the vent on your corny keg and turn it 90 degrees to lock it open.
Slowly increase regulator pressure while checking for liquid flow. You only need 1 PSI or so to get it to start flowing. You may need to hold one hand around the carboy cap on the initial pressurized start to keep it from popping off. Once you have flow and the siphon is running, you can lower the pressure just a touch to keep excess pressure from building in the carboy. Use good judgement and don't do anything that would allow more than 1psi to build in a glass carboy.